                        3Com (R) Corporation
                     TokenDisk (R) Diskette for
  The 3C319 TokenLink Velocity ISA Token Ring Network Interface Card
          NDIS 3.0 Drivers and Windows for Workgroups 3.11 


Microsoft Windows for Workgroups 3.11
-------------------------------------
The following describes the procedure for installing the protected-mode
NDIS3 (TLNK3.386) driver under Windows for Workgroups. 

NOTE: It is assumed that Windows for Workgroups has already been installed.

1.  Start Windows.
    
2.  Open the Network group and double-click Network Setup.

3.  To install the network adapter, click Drivers...

4.  In the Network Drivers window, click Add Adapter...

5.  From the list of network adapters, select Unlisted or Updated Network
    Adapter.

6.  Network setup now requires a vendor-provided network driver diskette.
    Insert the TokenDisk diskette in drive A:, and type the following 
    path for the location of the NDIS driver:
    
    A:\WFW311
    
    Click OK.

7.  From the Unlisted or Updated Network Adapter screen, select 3Com 
    TokenLink ISA NIC (3C319/3C619C) and click OK.
    The Network Setup screen now lists the NIC, along with the 
    default protocol stacks:
    
    3Com TokenLink ISA NIC (3C319/3C619C) (NDIS2/NDIS3)

8.  The Windows Setup program asks if you want to replace the Enhanced 
    Mode Protocol Manager with the version you are installing now.
    Click Yes to All.

9.  The Windows Setup program asks for the NDIS.386 file.  Insert
    Microsoft Windows for Workgroups 3.11 Disk 7 and click OK.

10. When prompted for the TLNK3.386 driver, insert the 3Com TokenDisk
    diskette in the A:\ drive.  
    
11. Type the following path to load the NDIS3 driver:

    A:\WFW311
    
    Click OK.

12. When prompted for the TLNK3.DOS driver, insert the 3Com TokenDisk
    diskette in the A:\ drive.  
    
13. Type the following path to load the NDIS2 driver:

    A:\NDIS2\DOS
    
    Click OK.

14. The PROTOCOL.INI and SYSTEM.INI files have now been modified.  WFW 
    saves the old versions with the extension .001, where the number is
    incremented every time a new PROTOCOL.INI or SYSTEM.INI is generated.  
    Click OK.

16. When prompted, restart the computer.

NOTE: The TokenLink NIC uses areas of upper memory to transfer data.  The
      Windows memory manager (EMM386) uses the same areas of upper memory.
      To reserve the required areas of upper memory for use by the NIC,
      add the eXclude parameter to the EMM386 device statement in the
      CONFIG.SYS file.  The following example assumes the NIC is 
      configured to the default shared RAM and BIOS/MMIO base addresses:

      DEVICE=C:\WINDOWS\EMM386.EXE NOEMS X=D800-DBFF X=CC00-CDFF



  (%VER WFWNDIS3.TXT - 3.0 Drivers and Windows for Workgroups 3.11 v1.0a)

